Wine-mate SSHWC Series User Manual

wwwwww..wwiinneemmaattee..ccoomm Duct Split Cooling System Installation, Operation & Care Manual WM-2500SSHWC WM-4500SSHWC WM-6500SSHWC WM-8

- 9 -In case there is excessive frost, the parameters FnC = C-y, idF =

- 10 -Care Guide In general, always unplug system or disconnect pow

- 11 -User’s Troubleshooting This Troubleshooting Chart is not prepar

- 12 -high or not cooling and running continually b. Cellar too lar

- 13 -fan running but condensing unit not running b. Failed components

- 14 -high ambient temperatures or airflow restriction d. Defective co

- 15 -Installer’s Instructions Federal law requires that WINE-MATE spl

- 16 -CAUTION: Liquid and suction line locations may differ from what

- 17 - Fig. 4 WM-250~850SCU-WC Condensing Unit

- 18 - Fig. 7 Temperature Controller (4.25”L X 3.75D X 4.25”H) 2. Te

- 1 -Important Safety Information WARNING: • Do not use a ground fau

- 19 -4) There is a gravity drain system used, so the unit shall be i

- 20 - BACK POSITION FRONT POSITION

- 21 -evaporator unit (including liquid line connection, solenoid valv

- 22 -2) Charge the system through both suction and discharge valves

- 23 -3) The subcooling at the condensing unit shall be around 10°F.

- 24 - Low subcooling 5) High suction pressure and high head pr

- 25 -Electrical Wiring Diagrams CAUTION: • Hidden lines are the fi

- 26 - Fig. 15 WM-6500~8500SSHWC Electrical Wiring Diagram

- 27 -Customer Support If you need further assistance, please contact

- 28 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple

- 2 -Table of Contents Cellar Construction.…………………………….……………..3 Fea

- 29 -VINOTEMP will, at its discretion, repair or replace the unit and

- 3 -Cellar Construction This is only a guide and shall be considered

- 4 -Features and Specifications • Wine-Mate duct split cooling syst

- 5 -The specifications and dimensions are listed as follows: Model N

- 6 -Temperature and Humidity 1. The controller Fig. 2 TEMPERATURE C

- 7 -4) Alarm Signals The alarm codes are described as follows. MES

- 8 -6. Parameter Programming 1) Press and hold the SET + keys until