wwwwww..wwiinneemmaattee..ccoomm Duct Packaged Cooling System Installation, Operation & Care Manual WM-4500DS WM-6500DS WM-8500DS wwwwww.
- 9 -In case there is excessive frost, the parameters FnC = C-y, idF =
- 10 -Care Guide In general, always unplug system or disconnect pow
- 11 -User’s Troubleshooting This Troubleshooting Chart is not prepar
- 12 -high or not cooling and running continually b. Cellar too lar
- 13 -fan running but condensing unit not running b. Failed components
- 14 -high ambient temperatures or airflow restriction d. Defective co
- 15 -Installer’s Instructions Federal law requires that WINE-MATE sp
- 16 - Fig. 5 Temperature Controller (4.25”L X 3.75D X 4.25”H)
- 17 -3. Mounting • The unit must be mounted on a floor or slab that
- 18 -• If the low ambient condition kit is used, turn off the compre
- 1 -Important Safety Information WARNING: • Do not use a ground fau
- 19 -Service Instructions 1. Service Valve Operations BA
- 20 -Head pressure setting: Cut out=230 psig; Cut in=150 psig; Differ
- 21 - Fig. 10 Condenser Fan Cycle Control B. Use of the crankcase h
- 22 -2. Connecting Electrical Wires Connect all electrical componen
- 23 -7) If the superheat is high, check the subcooling first to know
- 24 -4) High to normal suction pressure and high head pressure Low s
- 25 -Electrical Wiring Diagrams CAUTION: • Hidden lines are the fi
- 26 - Fig. 17 WM-8500DS Electrical Wiring Diagram Fig. 18 Low Amb
- 27 - Fig. 19 Low Ambient Temperature WM-8500DS-LA Electrical Wiring
- 28 -Customer Support If you need further assistance, please contact
- 2 -Table of Contents Cellar Construction.…………………………….……………..3 Fea
- 29 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple
- 30 -VINOTEMP will, at its discretion, repair or replace the unit and
- 3 -Cellar Construction This is only a guide and shall be considered
- 4 -Features and Specifications • Wine-Mate duct packaged cooling s
- 5 -NOTE: To prepare rough-in, leave minimum 4” clearances for electr
- 6 -Temperature and Humidity 1. The controller Fig. 2 TEMPERATURE C
- 7 -4) Alarm Signals The alarm codes are described as follows. MES
- 8 -6. Parameter Programming 1) Press and hold the SET + keys until
Comments to this Manuals